Matek F722-MINI SE Flight Controller

Is it a 20x20mm or 30x30mm flight controller? Well the F722-MINI SE from Matek Systems is actually both. I guess you could argue that it is a 20×20 FC with a 30×30 adaptor, but either way, you can use this with any quad!

Apart from that the F722 MINI SE packs alot of other cool features like 8 PWM outputs, 5 UARTS, MPU6000 Gyro, a Barometer and 32M blackbox. But the novel features of this board is that is features on/off power switching for your VTX, so you can turn it on or off remotely. It also includes the popular switchable dual camera input with the ability to turn your VTX on and off remotely via your radio. Suitable for both Betaflight and Inav with dedicated firmware targets.

• MCU: 216MHz STM32F722RET6
• IMU: MPU6000 (SPI)
• OSD: AT7456E (SPI)
• Baro: Infineon DPS310 (I2C)
• Blackbox: 32M-byte Flash memory (SPI)
• 5 x Uarts (1,2,3,4,6) with build-in inversion
• 1 x Softserial supported
• 8 x Dshot/Proshot/oneshot outputs
• 1 x I2C
• 1 x SH1.0 8pin connector (Vbat/G/Curr/R6/S1/S2/S3/S4)
• 3 x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
• Vbat filtered output power for VTX, Switchable via AUX (modes tab-user1)
• Dual Camera image switchable via AUX (modes tab-user2)
• Convertible 20mm to 30.5mm mounting
• Camera control: Yes
• Smartaudio & Tramp VTX protocol: Yes
• DJI OSD: Yes (any spare Uart Tx & Rx)
• WS2812 Led Strip: Yes
• Beeper: Yes
• RSSI: Yes
• Additional ADC for INAV analog airspeed

• Input: 6~36V (2~8S LiPo)
• BEC: 5V 2A
• LDO 3.3V: Max.200mA
• Battery Voltage Sensor: 1:10 (Scale 110)
• No Current Sensor built-in, supports external current sensor of PDB/4in1

• INAV target: MATEKF722mini
• BetaFlight unified target: MATEKF722mini(MTKS)
• BetaFlight legacy target: MATEKF722SE

• Mounting
• 20 x 20mm/F3mm with Silicon Grommets
• 20 x 20mm/F2mm with Silicon & Brass Grommets
• 30.5 x 30.5mm/F3mm with Conversion Plate and Silicon Grommets
• Dimensions: 28 x 28 mm
• Weight: 5g

• 1 x FC F722-MINI SE
• 1 x 20mm to 30.5mm conversion plate
• 6 x Silicon grommets M4 to M3
• 6 x Brass grommets M3 to M2
• 1 x 5cm SH1.0 8pin cable
• 2 x SH1.0 8pin connectors