In Stock
Out Of Stock

iFlight SucceX-D F7 TwinG Mini Flight Controller

AVAILABILITY: In stock (6 items)

VENDOR: iFlight


or 6 weekly interest-free payments from $11.06 with Laybuy
Wiring Diagram

The SucceX-D Mini F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the included wire harness. In addition, iFlight added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.

But the real magic of this flight controller lies in its TWIN GYRO configuration.

The TwinG uses two identical gyros oriented side by side with one offset 90 degrees from the other. Betaflight uses GYRO FUSION to blend and average the information from both gyros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters can be lowered in most cases as well, which brings a significant decrease in delay.

With plenty of processing power and UARTS, this is also the perfect flight controller for long-range GPS builds. And the TwinG configuration makes it the perfect Flight Controller for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune.

SucceX-D F7 Mini Flight Controller
  • MCU: 216MHz STM32F722RET6
  • Gyro: 2 x ICM20689(SPI)
  • Baro: No
  • Blackbox: Onboard 32MB
  • Betaflight OSD: Yes
  • BEC: 5V 2.5A / 9V 2.5A
  • Current sensor scale: 100
  • Inverter for SBUS input (UART2-RX)
  • Smart audio & Tramp VTX protocal supported
  • Beeper pad: Yes
  • RSSI imput pad: No
  • Uarts: 5
  • Motor outputs: 4
  • 8 pin 4in1 ESC port
  • 6 pin DJI Air Unit port
  • Input voltage: 2 - 6S, Max 8S
  • Target: IFLIGHT_F722_TWING
  • Mounting hole: 20*20mm, ø 3mm with grommets ø 3mm
  • Size: 29*29mm
  • Weight: 5.76g
  • USB Type-C

  • 1 x SucceX-D F7 TwinG Mini Flight Controller
  • 4 x silicon grommets
  • 1 x 6 pin DJI Air Unit harness
  • 1 x 8pin 4in1 ESC harness
Wiring Diagram

Drone Parts Garage uses cookies to deliver the best experience on our website. By continuing to use this website, you are agreeing to our use of cookies. You can learn more about our cookie policy under ‘Cookie Policy’.