Holybro Kakute F7 Mini V3 Flight Controller

he upgraded Holybro Kakute F7 flight controller is a 20×20 board that makes it easy to build your multirotor. It integrates flight controller (FC) and onscreen display (OSD) in one.

The new Kakute F7’s layout now support DJI Air Unit connectivity via plug and play harness, mounting holes got upgraded to M3 with anti-vibration grommets that makes it easy to wire up the other components of the multirotor while keeping the build neat and tidy.

Pinout Diagram

Kakute F7 Mini V3

• MCU: STM32F722RET6 32-bit processor,216MHz, 256Kbytes RAM, 512Kbytes Flash
• IMU: MPU6000 (SPI)
• Barometer: BMP280
• USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
• 5 hardware UARTS (UART1,2,3,4,6)
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported
• Onbord 16Mbytes for Blackbox logging
• 5V Power Out: 1.0A max
• 3.3V Power Out: 0.2A max
• Dimensions: 30x30mm
• Mounting Holes: Standard 20mm square to center of holes
• Weight: 4g

Content Included

• 1 x FC board
• 4 x M3 Anti-Vibration Silicone Grommet Insert
• 1 x JST SH 8pin 150mm cable
• 1 x JST SH 6pin 150mm cable ( The cable that goes to the CADDX Vista Air Unit is included.)
• 1 x JST SH 6pin to GH 8pin 150mm cable ( The cable that goes to the DJI Air Unit is included.)
• 1 x JST SH 6pin to GH 8pin 80mm cable ( The cable that goes to the DJI Air Unit is included.)

Manual

Kakute F7 Mini V3 Manual