New
In Stock
Out Of Stock

Holybro Kakute F7 HDV Flight Controller

AVAILABILITY: In stock (8 items)

VENDOR: Holybro

$64.60

or 6 weekly interest-free payments from $10.76 with Laybuy
PRODUCT INFORMATION
Specifications
Manual
CUSTOMER REVIEWS
PRODUCT INFORMATION

Holybro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the board makes it much more convenient for you to connect HolyBro Kakute F7 HDV to the DJI FPV VTx, for both signal and power supply.

Features
  • Supports Betaflight, Butterflight, and Cleanflight
  • High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer
  • Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units
  • Dedicated bootloader button for easy firmware flashing
  • Low-profile design fits into even very compact frames
  • Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV monitors voltage directly from the power supply
  • Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up to 2A to DJI FPV VTx
  • Supports BLHeli pass-through for easy ESC upgrade and configuration
Specifications
Kakute F7 HDV
  • MCU: STM32F745 32-bit processor
  • IMU: MPU6000
  • Barometer: BMP280
  • USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
  • 6 hardware UARTS (UART 1,2,3,4,6,7)
  • All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”
  • Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported
  • TF card for Blackbox logging
  • Dimensions: 35 x 35mm
  • Mounting Holes: Standard 30.5mm square to the center of holes
  • Weight: 8g

Including
  • 1 x FC board
  • 4 x M3 Damping Ball
  • 1 x JST SH 8pin 150mm cable
  • 1 x JST GHR 8pin to JST GHR 6pin 80mm cable
  • 1 x JST GHR 8pin to JST GHR 6pin 150mm cable
Manual
CUSTOMER REVIEWS

Drone Parts Garage uses cookies to deliver the best experience on our website. By continuing to use this website, you are agreeing to our use of cookies. You can learn more about our cookie policy under ‘Cookie Policy’.

COOKIE POLICY
Pre-loader